Search eceee proceedings

Fit for renewables through low temperature readiness of buildings

Panel: 8. Innovations in products, systems and building technologies

This is a peer-reviewed paper.

Authors:
Martin Pehnt, Ifeu – Institute for Energy and Environmental Research Heidelberg, Germany
Peter Mellwig, ifeu – Institute for energy and environmental research Heidelberg, Germany
Julia Lempik, ifeu – Institut für Energie- und Umweltforschung Heidelberg gGmbH, Germany

Abstract

When oil or gas boilers break down, they are often substituted by yet another generation of oil or gas boilers. However, once a fossil heating system is installed, the next chance for a change to renewable energy will occur only in 15 to 20 years. One problem is that in practice not every building is ready for renewables – particularly for heat pumps. The required high temperatures in the heating system frequently block the switch to renewable energy.

Most existing buildings do not have to be completely modernized to be heated with heat pumps or low temperature district heating. Usually, a few targeted measures enable lower system temperatures: insulation of specific envelope components and improvements to the heat distribution. This paper proposes a new “standard” that combines efficiency measures and the optimization of the heating system to open the door for renewable heating: “Fit for renewables through low temperature readiness (LT ready)”.

We will demonstrate how we developed the LT ready standard based on static and dynamic building calculations, what benefits it has in terms of enhanced capacity of buildings to include renewables, increased seasonal efficiency, lower load demand, and higher resilience of the building. For a definition, we suggest that buildings are LT ready when insulation measures, heating circuit optimization, or efficient domestic hot water supply have been optimized such that the room temperature required by the users is ensured with a maximum flow temperature of 55°C. LT readiness is not a final target standard, but an intermediate step in the renovation biography of a building towards carbon free buildings.

The paper will also present how LT readiness and “Fit for renewables” can be incorporated into energy audits, building roadmaps, funding schemes, and regulation, as exemplified in the “Building Energy Act 2.0” developed as a blueprint of a revised building code.

Downloads

Download this presentation as pdf: 8-081-22_Pehnt_pres.pdf

Download this paper as pdf: 8-081-22_Pehnt.pdf