Search eceee proceedings

Safety and energy performance of photovoltaic equipment: the case of the the Brazilian labelling program - PBE PV

Panel: 8. Innovations in products, systems and building technologies

This is a non-peer reviewed extended abstract. No paper available.

Author:
Pedro Costa, Brazil

Abstract

Renewable energy capacity addition set another record in 2021, driven by solar PV, and despite pandemic crisis and rising costs of key materials, solar PV is expected to continue setting new records, growing faster than in the previous 5 years (IEA, 2021).

However, for this growth to be sustainable, there is a must to consider issues such as equipment safety, system performance, electric grid, environmental impacts, and others, which must be addressed by governments together with stakeholders.

Many countries have established legislations for the qualification of PV equipment, and recently EU is examining the conditions for adopting an energy labelling scheme. In order to contribute to the debate, we present the experience of the Brazilian PV Equipment Labelling Programme (PBE-PV), whose initiative complete 20 years in 2022.

Since 2002, Inmetro, a national regulatory agency, has been working with the issue of PV equipment, under the aegis of the Brazilian Labelling Programme (PBE). In 2008, Inmetro launched the first edition of PBE PV, as a voluntary certification scheme, in 2011, adopted a mandatory labelling approach, and in 2022, launched a fully improved programme, of mandatory declaration of conformity, which is the case presented here.

PBE PV stablishes technical, marking, declaration of conformity and labelling requirements for PV equipment, with mandatory compliance to market products in Brazil. All suppliers are subject to premarket controls, such as registry and imports approval, and market surveillance.

For PV modules, the regulation covers products of nominal power ≥ 5 W, of silicon cells, thin films, or heterojunction. It stablishes performance (power determination, conversion efficiency) and electrical safety (insulation, current leakage in wet conditions) requirements. The evaluation is by family of products, covering 5 tests of IEC 61215. After all, module’s efficiency is calculated and classified from “A” (>20%) to “E” (<14%).

For charge controllers, the regulation covers PWM and MPPT types. It stablishes performance (self-consumption, internal power loss) and electromagnetic compatibility requirements. The evaluation is by model, and the tests are based on Inmetro’s own procedures, covering self-consumption, internal losses, setpoints, overvoltage, reverse polarity and short circuit protections.

For batteries, the regulation covers electrochemical technologies of lead-acid, nickel-cadmium, lithium-ion, and others. It stablishes performance (capacity, charge cycles, self-discharging) and electrical safety (management system, overheating, overload) requirements. The evaluation is by family of lead-acid or by model of lithium batteries, and the tests are based on NBR and IEC standards, covering real capacity, charge cycles, self-discharge, overload, overcurrent, and overheating controls.

For inverters the regulation covers off-grid, grid-tie, and hybrid inverters ≤ 75 kW. It stablishes performance (euro efficiency), electrical safety (polarity inversion, insulation resistance, arc fault, mechanical disconnection), grid stability and compatibility (harmonic distortion, supportability and immunity) and electromagnetic compatibility (radiofrequency disturbances) requirements. The evaluation is by model, and the tests are based on NBR and IEC standards, covering polarity inversion, insulation failures, harmonics distortion, over/under voltage, over/under frequency, unintentional islanding, conversion efficiency and radiofrequency emissions.

PBE FV has currently 13.176 registered products, being recognized as an important regulation to protect national market from unsafe and underperforming equipment. Although the recent regulatory process involved a tough and complex negotiation with stakeholders, it was possible to achieve good levels of commitment, and to introduce new requirements, anticipating risks faced by other countries such as blackouts, arc faults and radio frequency disturbances related to PV equipment.

Downloads

Download this display (photo) as pdf: 8-158-22-displayphoto.pdf