Search eceee proceedings
Global green steel opportunities surrounding high quality renewable energy and iron ore deposits
Panel: 9. Deep decarbonisation of industry
This is a non-peer reviewed extended abstract. No paper available.
Authors:
Alexandra Devlin, University of Oxford, United Kingdom
Aidong Yang, Department of Engineering Science, University of Oxford, United Kingdom
Abstract
The steel sector’s foreseeable decarbonisation demands reconstruction of not only production processes, but the entire iron and steel supply chain. This study involved a global industrial relocation analysis of the most economically and energetically efficient steel supply chains in the projected 2030-2050 timeline where all energy is derived from renewable electricity and green hydrogen. A facility-level optimisation model was developed, largely dependent on the two key inputs to primary iron- and steelmaking: high quality iron ore and energy. The shift from fossil-based to renewables-based steel production necessitates a comprehensive geospatial approach to industrial change as the power potential of renewable energy and iron (Fe)-content of the nearest iron ore deposit are locally unique. Furthermore, energy and ore costs account for about 20% and 25%, respectively, of the levelised cost of steel (LCOS), so strategic location of decarbonised iron and steel-making facilities will be indispensable for competitive zero-carbon steel. Historically competitive steel regions, commonly located nearby coal mines and natural gas reserves, must be re-evaluated in a decarbonised context.
This study investigated the simplest steel supply chain, where iron ore was upgraded to highest possible value (i.e. steel) at source (i.e. deposit), for transportation to the nearest port for export. It was hypothesised that iron ore producers should, considering energetic and economic efficiency benefits, play a more central role in a decarbonised steel industry. The bottom-up approach also established clear foundations for more complex trade strategies. Initially, the top-12 iron ore producing countries (by fraction of global output) were assessed, in addition to Guinea (a location with high quality yet untapped iron ore resources). All 185 iron ore deposits in these countries (Schulz & Briskey, 2005) were investigated, aggregated into 39 regions to allow regional renewable energy profiles to be used for modelling in combination with the region-specific Fe-content of iron ore deposit.
The importance of high-quality iron ore inputs is often neglected in decarbonised steel literature, a gap this study begins to address. Green hydrogen-based direct reduction of iron is likely to dominate primary steel production in a zero-carbon future (Mission Possible Partnership, 2021), which demands an even higher quality ore (67% Fe-content) in comparison to the traditional blast furnace route (65% Fe-content) (Barrington, 2018). The average Fe content of extracted ore varied across these countries from 20% to 71%, with a global average of 62% (U.S. Geological Survey, 2022).
A linear optimisation model was developed for lowest cost green steel production with hourly temporal resolution. The key outputs were the LCOS, energy consumption, and renewable energy infrastructure capacity for each regional facility with a 1 Mtpa steel capacity, located adjacent to the ore deposit, and powered by 100% solar and onshore wind energy. The islanded energy system was optimised to balance infrastructure capital expenditure with load factors, through the dynamic management of renewable energy supply, storage infrastructure and production processes.
The results revealed competitive market conditions alongside favourable producer locations for the decarbonised steel market. Machine learning techniques were then applied to the results to derive a simplified green steel investment model and expand the utility of the study. This enabled expansion of the global assessment from 39 regions to 306 deposits and laid the foundations for future work where more complex supply chains will be assessed, including the trade of hydrogen and hot briquetted iron, and delivery to demand markets.
Downloads
Download this presentation as pdf: 9-036-22_Devlin_pres.pdf
Panels of
1. Dynamics of consumption: less is more?
2. Efficiency and beyond: innovative energy demand policies
3. Policy, finance and governance
4. Monitoring and evaluation for a wise, just and inclusive transition
5. Towards sustainable and resilient communities
6. Energy-efficient and low-carbon mobility for all
7. Policies and programmes for better buildings
8. Innovations in products, systems and building technologies


